Beurer MPE 100 - Manual (Page 15)

15
Inserting a professional attachment
1. Turn the safety lock to the open position and carefully push the selected professional at-
tachment onto the hand-held device, up to the stop.
2. To lock the professional attachment in place, carefully turn the sealing ring onto the closed
position .
3. Attach the protective cap for nail dust to the tip of the hand-held device
from the top.
4. Connect the hand-held device cable to the hand-held connection on the
base station.
Important
Make sure the speed controller is set to the lowest setting before connecting the mains adapter
to the mains electricity.
5. Insert the mains adapter into the socket.
4. Operation
Warning
Check the results during the treatment. this applies in particular for diabetics as they have
less sensitive hands and feet. Stop treatment as soon as it becomes unpleasant.
Important
Ensure the axle can always rotate freely. Do not permanently block the axle as otherwise
the device may become hot and damage.
When filing, always move from the outside of the nail towards the tip!
Please observe that professional attachments show reduced performance on soaked
or wet skin. For this reason, we recommend that you do not soak the foot in water
before treatment.
1. Press the ON/OFF button to start treatment.
If the safety lock is not turned to the closed position, the device cannot be switched
on.
2. Select the desired speed using the speed controller.
3. Select the desired direction of rotation using the buttons for clockwise and anti-clockwise
rotation.
4. Do not press too hard and always carefully move the attachments towards the area to be tre-
ated. Move the device towards the area to be treated and apply slight pressure while slowly
moving the device in circles.
If a large amount of pressure is placed on the rotating attachment, the device automa-
tically switches off. Press the On/OFF button again to switch the device back on.
5. Apply moisturiser to the treated areas after each use.
5. Cleaning
Warning
Before beginning cleaning, always pull the mains adapter out of the socket!
• Clean the base station and the hand-held device with a damp cloth. If it is very dirty, you can
also moisten the cloth with a mild soapy solution.
• For hygienic reasons, you may use alcohol and a cloth or brush to clean the attachments. Al-
low the attachments to dry afterwards.