Care and maintenance of the beurer salonpro system – Beurer IPL 10000+ User Manual

Page 38

Advertising
background image

38

Note

You can “fold in” your lips or press them together to make the treatment area more taut, or apply a

thick layer of white eyeliner to the lips and around the edge of the lips. The white line ensures that the

energy of the flash is reflected and does not reach your lips, should you accidentally apply a pulse to

your lip.

8.4 Treating the cheeks and jaw

Position the treatment window of the applicator as shown in the figure. At each point, trig-

ger a pulse and move from one side of the check or jaw to the other.

8.5 Treating the neck and chin

Position the treatment window of the applicator as shown in the figure. At each point, trig-

ger a pulse and move from one side of the neck or chin to the other.

Note

The skin on the lower third of the neck is more sensitive. For this reason, avoid overlapping treatment

areas.

8.6 care after facial treatment

• Apply a soothing lotion such as aloe vera.
• Do not use exfoliators, whitening lotions or similar products for at least 24 hours, as this could irritate

the treated skin.

• For at least 48 hours after the treatment, avoid more than 15 minutes of direct exposure to the sun. If

recently treated skin is exposed to sunlight during this period, sun protection with SPF 30 or higher

must be applied.

• Do not remove hair on the treated areas using wax or tweezers.
Remember that it may take a complete hair growth cycle for hair removal to be complete.

9. care and maintenance of the beurer SalonPro System

9.1 cleaning the beurer SalonPro System

After each hair removal session, it is recommended that you clean your beurer SalonPro System, paying

particular attention to the light area.

IMPORTANT

Never immerse the beurer SalonPro System or any of its parts in water!
• Before cleaning, unplug the mains plug of the beurer SalonPro System.

• Use a clean, dry cloth and cleaning agent especially intended for electronic devices to gently wipe

the surface of the beurer SalonPro System, paying particular attention to the light surface.

9.2 Replacing the cartridge

The cartridge has a life cycle of up to 250,000 light pulses, which is sufficient for up to 40 years for nor-

mal use (one user, full body treatment including legs, arms, armpits, bikini zone and face). This means

that the cartridge for this model does not usually need to be replaced.

Advertising
This manual is related to the following products: