Beurer WL 32 - Manual (Page 19)

19
Note
For this function, use the mains adapter provided. When you
are listening to the radio or have activated the goodnight
function, the “mood light with change of colour” function is
deactivated. Only light without change of colour is possible
in this mode.
• Press the Zz button.
The LED light begins to light up gradually.
• To activate the lamp function, press the Zz button again.
“ L 09” will flash on the display (brightness level 09).
• Using the /buttons, set your desired brightness level
(L 00 to L 15).
• To activate the mood light with change of colour, press the
Zz button again.
The mood light with change of colour begins to light up.
Wait a few seconds for the colour to change.
• To set one of the mood lights permanently (without
change of colour), press the Zz button again.
• To switch off all light functions, press the Zz button again.
6.8 Listening to the radio
The wake-up light has a flexible wire antenna on the rear of
the device. Uncoil the wire and extend it fully to ensure the
best reception.
• To switch the radio on, press the button.
“ on” will flash on the display first. After approx. 10 seconds,
mhz will appear on the display with the currently set fre-
quency.
• Using the /buttons, set the desired frequency.
• To start automatic search, press the /button down
briefly and then release it. The search will now start and
will stop automatically as soon as a radio station has been
found.
• To change the volume of the radio, press the button.
Using the /buttons, set the desired volume.
• To switch the radio off again, press the cover of the lamp
(at the front) downwards.
Note
When you are listening to the radio, the “mood light with
change of colour” is deactivated. Only light without change
of colour is possible in this mode.
6.9 Storing radio stations
You can store up to 10 radio stations on the wake-up light.
• To switch on the radio, press the
button.
• Using the /buttons, set the frequency of the radio sta-
tion you would like to store.
• To store the selected radio station, press and hold the
button for approx. 2 seconds. O1 (memory space
number) will flash on the display below the frequency.
• Select the desired memory space number by pressing the
button briefly. To save the transmitter to the desired