Boyertown nrgMax Universal Oil Control V4.0 - Manual (Page 6)

INSTALLATION
When Installing this Product...
1. Read these instructions carefully. Failure to follow them
could damage the product or cause a hazardous
condition.
2. Check the ratings and specifications given in the
Instructions and on the product to assure the product is
suitable for your application.
3. Installer must be a trained, experienced service
technician.
4. After installation is complete, check out the product
operation as provided in these instructions.
CAUTION
Disconnect power supply before wiring to prevent
electrical shock or equipment damage.
Location and Mounting
The 9103i is mounted in the appliance wiring
compartment using four No. 6 screws (obtained locally)
through standoffs on the corners of the board.
Wiring
All wiring must comply with local codes and ordinances.
Disconnect power before making wiring connecti
nrgMAX (division of Bob Tonner Applied Research Inc) Pickering, ON, 289-800-7131 www.nrgmax.ca
Reserved for
future
options
NO
OPTIONS
SELECTED
PSC
Enhanced
Mode
Setting Options
F1
F3
F2
F1
F3
F2
F1
F3
F2
F1
F3
F2
Blower-On
Delay set to
75 Seconds