Boyertown Solaia Double Wall Direct Vent Kit - Manual (Page 6)

6
Termination Connection
1. Slide the terminal inner section over the flexible vent pipe.
2. Attach the adaptor as per the joint assembly instructions.
3. Apply a bead of sealant around the flue collar and slide on adaptor and tighten gear clamp.
4. Seal the seam on the adaptor.
5. Slide the terminal inner section over the terminal outer section and secure by tightening the
gear clamp.
6. Stretch the intake flex to the desired length and slide over intake collar and secure by
tightening the gear clamp.
7. Seal the gap between the vent pipe and the terminal inner section with silicone sealant.
JOINT ASSEMBLY
1. Apply Sealant to “threaded” end of the vent adaptor.
2. Insert the threaded end into the vent pipe. Screw the adaptor into the vent pipe in a counter
clockwise direction. The adaptor should be inserted fully until it is tight. If it does not
completely screw into the vent, unscrew and repeat.
3. Tighten the gear clamp on to the outer sleeve to complete the joint assembly.