Bronkhorst CEM W-300B - Manual (Page 16)

BRONKHORST HIGH-TECH B.V.
5 Cables
5.1 EMC and cables
All system set-ups described in this manual carry the CE-mark.
Therefore they have to comply with the EMC requirements as are valid for this kind of equipment.
However compliance with the EMC requirements is not possible without the use of proper cables and
connector/packing gland assemblies.
Screens of cables should be carefully connected at both ends of the cable to the metal housing of the
connector for good EMC behaviour.
For sensors and valves follow the guidelines as explained in the appropriate manuals.
Warning: the “CEM power” connector is a mains power inlet.
Use standard Bronkhorst® cables 7.03.583 for connecting the CEM W-300B to the Readout unit or
7.03.584 for connecting the CEM W-300B to a non-BHT control unit.
The symbol on the CEM indicates the location of the power inlet
page 16 9.17.082