BUG-O Systems CWP-7 - Manual (Page 7)

7
MAKING A WELD
1. Connect the ground cable to the workpiece. The ground cable must make good electrical contact
with the work.
2. Set Weld ON/OFF Switch to the OFF position.
3. Depress red STOP button.
4. Position the welding gun at the start position using the Racking System CBP-1640 and the rotation
controls. Position the electrode in the joint. The end of the electrode may be lightly touching the work.
5. Depress the black RESET button to set a new Home position.
6. Using the keypad, call up the desired program number or input a new program. When finished, press
“D” to review the program data.
7. Set the Weld ON/OFF Switch to the ON position.
8. Depress the green START button to begin the weld program.
9. Turn on the FLUX RECOVERY VACUUM Switch to the ON position.
10. The CWP-7 will automatically stop at the end of the weld program.
WARNING: When using an open arc process, it is necessary
to use correct eye, head and body protection.
SETUP AND OPERATION, CONT'D.