BUG-O Systems BVW-1000 - Manual (Page 6)

5
will be used or is being used.
F.
You can obtain the P-1 “Safe Handling of Compressed Gas in Containers” published
by CGA from the compressed gas organization-----
Jefferson Daves Highway, Arlington,
VA22202. Read through and understand the items on compressed gas cylinders and
corresponding equipments.
6. Notes for electrical operations
A.
Utilize the opening switch on the fusing box to cut off the input power source before
operating this equipment.
B. Install the equipment according to the national electrical requirements, local laws and
regulations and the suggestions from the manufacturer.
C. The equipment should be grounded according to the national electrical requirements
and the suggestions from the manufacturer.
7. Equipments that can be classified into internal combustion
engines
A. The engine should be shut down before the troubleshooting and maintenances unless
it needs to run during the maintenances.
B. The engine should be operated in an open place with good ventilation conditions, or
else the waste gas must be exhausted outdoor.
C. The refueling is forbidden near the welding arc or when the engine is running. The
engine should be stopped and then refuel until it cools down, avoiding the spilling fuel
volatilizes to contact to the hot parts of the engine and then fire is caused. If the fuel
spills out, then engine can be started only when the spilling fuel is wiped clean.
D. Keep the safety covers and devices being at appropriate places and the maintenance
should be conducted on time. During the starting, operation and maintenance of the
equipment, the hair, clothes and tools should be kept away from V-belts, gears, fans
and other moving parts.
E. Sometimes, the protection cover must be disassembled to facilitate the maintenance.
Keep in mind that the protection cover can be disassembled if it is necessary and it
should be recovered quickly after the maintenance. In addition, it is necessary to be
cautious when you work near moving parts.
F. Hands are forbidden to be near the fan. When the engine is running, it is forbidden to
push the control lever of the gas throttle forcedly regardless of the speed governor or
the idler wheel.
G. When the engine or the welding power source is rotated during maintenance,
connections of the sparkplug, the ignition distributor, the electromagnetic generator
and others must be disconnected to prevent the accidental starting of the gasoline
generator.
H. To avoid scalds, the pressure cover of the radiator is prohibited to open when the
engine is still hot.