BUG-O Systems UNI-BUG II - Manual (Page 14)

11
BUG-1855 UNI-BUG WELDING GROUP /
EXPLODED VIEW / PARTS LIST
ITEM QTY PART NO. DESCRIPTION
1 2 BUG-1853 Machined Rack 7-1/2" (191 mm)
2 1 BUG-1881 Cable Anchor w/Swivel Clamp
3 1 BUG-2708 Clamp
4 1 BUG-5451 3.5" Rackholder (88.9 mm)
5 1 BUG-5462 Right Angle Clamp
6 1 CON-1020 Clamp
7 2 FAS-0957 Fit Hd Soc Scr 1/4-20 x 3/4
8 1 UNI-1036 Rackrider w/Post
2
5
3
4
7
1
1
8
6
14
The UNI-BUG II can be adapted for dual welding applications as shown
below. A double racker mounting angle is bolted directly onto the left side of
the machine using two 1/4-20 socket head cap screws. Two 3.5" (88.9 mm)
rackholders are then mounted to the angle, each engaged with a 7-1/2" (191
mm) rack positioned horizontally in opposite directions. At the end of each
horizontal rack, a right angle clamp block is attached allowing for an addi-
tional rackholder and 7-1/2" rack to be mounted vertically. At the end of each
vertical rack, a swivel clamp assembly and torch clamp are added. A cable
anchor with swivel clamp is mounted to the front right side of the UNI-BUG
II to complete the set up.
UNI-BUG II FOR DUAL WELDING
A UNI-BUG II converted for dual welding using a UNI-1350 UNI-BUG Dual
Welding Group.
RACK MOUNTING
The handle mounting bracket has been redesigned so that it can be
mounted on either the left or right side of the machine. This allows the rack-
holder and rack also to be mounted on either side. The welding gun can then
be positioned behind the drive desired, to reduce heating of the rollers.
UNI-1019 STEEL DRIVE ROLL
Optional hardened steel drive rolls are available for use when running on
a heated workpiece, which could melt the sleeves on the standard drive rolls.
Order (2) UNI-1019 Steel Drive Rolls.