Campomatic CH1360 - Manual (Page 7)

Installation
Ensure the power has been turned off before beginning this installation.
Information
To install this hood you will require two
assistants.
You will need the following tools and
material to complete this installation:
*
Drill
*
Flat head screwdriver
*
Phillips
head screwdriver or cordless drill and
Phillips head bit
*
Tin snips
*
3/8″nut driver
or ratchet with extension* measuring
tape* hand saw or jig saw* electrical
tape* duct tape
1. Remove the range hood from the carton.
2. Lay the hood upside down on a table
covered with cardboard or paper to prevent
scratching of the table or hood.
3. Hood installation should be within 0.8m
radius range.
4. We recommend that after installation the
bottom of the hood should be no less than
650mm and no more than 750mm above
the stove's heating elements and burners.
Installation
work and
electrical
wiring must
be done by
qualified
person(s) in
accordance
with all
applicable
codes and
standards,
including fire-
rated
construction.
8
≥
6
5
0
m
m