Campomatic CD907I - Manual (Page 11)

11
CD907I
Indicator Lights
“Drying Light”
This light indicated the appliance is in the drying phase.
“Cooling Light”
This light indicates that the appliance is in the cooling phase. At the end of drying, there is a
10 minutes cooling phase to cool the laundry.
“End Light”
“Overflow Light”
This light is on during the anti-creasing phase after the cooling phase.
It comes on when the water container is full, which remind you to empty the water container.
Note! Empty the water container after each load to avoid the alarm when use in next time.
“Filter Light”
It comes on after each load to remind you to clean the filter. If not clean the filter, the machine
perform well for the next use, but the drying efficiency will be influenced if not clean the filter for
many times.
“Child Lock Light”
This light indicated the appliance is locked.
Select the Power
Press the Power button to turn on the machine.
“Child Lock”Functions
After each use
Clean the filter.
Important
If the drying programme has to be stopped before it reaches the end,we recommend that you
turn the programme selector dial to position “Air Dry” and wait until the end of this cooling phase
before removing the laundry. This will avoid a build-up of heat inside the appliance. To do this first turn
the on-off switch and then turn to “Air Dry” and press the “Start” button.
Modifying the programm
Turn off the machine to restart a programme.
A t t he e nd o f t he p rogra mme
All drying programs end with 10 minutes cooling phase.If the laundry is not removed at the end
of the cycle, the dryer performs an anti-creasing phase(duration:30 minutes maximum).If you do
not remove the laundry ,the machine will remain in the standby status,after the anti-creasing phase.
The display shows " End" and the buzzer sounds for 15 seconds if you have selected the buzzer.Press the
, all the signal light will close. Power
When the machine is on,press meantime “Start/Pause”and“Buzzer” button for several seconds,
the system will lock all the buttons.Then,all buttons are invalid.If you want to make the
appliance to return to the normal state,then press“Start/Pause”and “Buzzer” button and button
for several seconds meantime again.
The function will be released in the following cases:
Open the door during operation
Take out condenser during operation
Water tank full
You can set again the “Child Lock” function when you restart the machine.