Campomatic D807E - Manual (Page 19)

Appendix
Installation
Connect the hose to whichever is the more convenient by pulling the ring nut (A) from the vent
outlet at the back, aligning arrows of hose and ring nut,fastening by screwing hose to the direction
of arrow and pushing it firmly back into place.
Advice:
If the hose is long and the room temperature low, the moisture
might condense inside the hose. This is an unavoidable natural
phenomenon. To prevent this water from Iying in the hose or
flowing back into the tumble dryer, it is advisable to drill a small
hole (dia. 3 mm) in the lowest point of the hose and to place a
small container below it.(See picture, point B).
A
Once connected to the dryer, run the vent hose to the desired
outlet point, it contains no more than two bends. As to the outlet
itself, if you have decided on a fixed wall/window grille, a good
local builder's merchant should be able to supply you with the
necessary fittings and installation advice.
B
A
D807e / D807es
ENG
19