Campomatic FRF254SS - Manual (Page 5)

3
Warnings
l
Don't use mechanical equipment or other methods to accelerate the defrosting process
except the means recommended by the manufacturer.
l
Don't use any electrical appliances in the food storage compartments except the model
recommended by the manufacture.
l
The R134a refrigerant and cyclopentane foaming material used in the refrigerator are
inflammable. All waste and discarded refrigerators shall be placed away from naked fire and
they are not allowed to burn.
New refrigerator is coming
l
Remove all packaging material before using the new refrigerator. This includes the foam
base and all adhesive tape holding the refrigerator accessories inside and outside.
l
Clean both the inside and outside of the refrigerator with wet cloth (a little detergent could
be added into the warm water to wash the cloth and then wipe it again with the clean water);
l
Prepare an independent two-pole socket with grounding contact for the refrigerator and it
shall not share a multi-purpose socket with other electrical appliances;
l
Do connect grounding wire! The grounding pole of the socket shall be provided with a
reliable grounding wire.
l
Open the refrigerator body and take out the accessory
(decorative cover for bottom beam) and the three
screws from the instruction packaging bag; then
install them into the bottom beam as shown by
the schematic diagram on the right.
Transport and Placing of Your Refrigerator
Transport
l
Keep upright and avoid squeezing or vibration during transport. Avoid a slant
angle over 45 degree during handling.
l
Avoid the door or top cap from being under excessive stress when moving;
otherwise, it may become deformed.
Placing
l
Place your refrigerator in a well-ventilated place and keep it from heat source
and direct sunlight. Don't place it in any humid or wet place so as to avoid rust and
weakening of insulation effect.
l
There shall be a space not less than 30cm from the top of your refrigerator and
not less than 10cm from both sides or the back of the refrigerator to the adjacent
walls respectively. This requirement is good for open and close of the door and
also for heat emission.
l The refrigerator shall be placed on a flat and firm ground (if not flat, you can use
the leveling legs for adjustment).
Keep Your Refrigerator Standing
l
Don't connect your refrigerator to the power supply immediately after it is placed
vertically. You should keep it standing for at least 6 hours before switching it on in
order to ensure it running well.
Note: Make sure the power wire is not pinned by the refrigerator or other
objects so as to avoid accidents arising from power wire faults. Please check
the voltage scope of your refrigerator against the actual power supply before
switching it on.
Note: The decorative cover for bottom
beam is used as ornament, so you can
choose not to install it. It won't affect the
refrigerator's performance or conditions
no matter whether you install it or not.
Decorative cover for bottom beam Screws
Electric diagram
Electric diagram
14
Correct Use for Your Refrigerator