Caple SBXC600SS - Manual (Page 6)

5
INSTALL THE HOOD
Minimum hood distance above cooktop must not be less
than 650mm.
A maximum of 750mm above the cooktop is highly
recommended for best capture of cooking impurities.
Distance over 750mm above the cooktop are at the
installer’s and user’s discretion - providing that ceiling
height and flue length permit.
1. Secure the hood mounting bracket to the wall using
ST 5 x 50mm mounting screws and dry wall anchors.
Align the hood body with the hood mounting bracket. Gently lower the hood until it
securely engages the bracket.
2. Fix the discharge collar into the air outlet adapter.
3. Attach an adequate length of 150mm round duct to the air outlet adapter.
4. Carefully slide the decorative chimney top down inside the decorative chimney
bottom. Carefully place the decorative chimney bottom into the recessed area of
the hood body top.
5. Secure the chimney mounting bracket to the wall using (2) ST 5 x 50mm
mounting screws and dry wall anchors.
6. Raise the decorative chimney top until its holes align with holes in the chimney
mounting bracket (located on the wall).
7. Level the hood and secure the chimney with 2 chimney bracket screws.
8. Fix the Decorative Chimney Bottom with 3 decorative Chimney Bottom screws
from inside of body.