Caple C232SS - Manual (Page 12)

12
Fig. 3.3
A
U
T
O
Fig. 3.4
ELECTRONIC CLOCK
(fig. 3.2)
The programmer is equipped with an
electronic clock with illuminated num-
bers which indicates hours and minutes.
Upon immediate connection of the oven
or after a power cut, three zeros will
flash on the programmer display.
To set the correct time of day it is nec-
essary to push the
button and then
the ( ) or ( ) button until you
have set the correct time (fig. 3.2).
In another way push simultaneously the
two buttons and at the same time
push the ( ) or ( ) button.
Note: If the clock is reset it deletes any
previously set programs
ELECTRONIC TIMER
The timer program consists only of a
buzzer which may be set for a maximum
period of 23 hours and 59 minutes.
If the AUTO symbol is flashing push the
button.
To set the time, push the button and
the ( ) or ( ) until you obtain
the desired time in the panel (fig. 3.4).
Having finished the setting, the clock
hour will appear on the panel and the
symbol will be illuminated.
The countdown will start immediately and
may be seen at any moment on the panel
by simply pressing the button
.
At the end of the time, the symbol
will disappear and the buzzer will sound
and continue for approximatley 7 min-
utes or until a button is pressed (not the
( ) / ( ) buttons). After a short
time the display will revert back to the
time of day.
SETTING THE FREQUENCY OF THE
AUDIBLE SIGNAL
The buzzer has 3 different tones and can
be changed by pressing the
( ) but-
ton, but only when the time of day is dis-
played
NORMAL COOKING WITHOUT THE
USE OF THE PROGRAMMER
To manually use the oven, without the
aid of the programmer, it is necessary to
cancel the flashing AUTO by pushing the
button (AUTO will be switched off
and the symbol will illuminate - Fig.
3.3).
Attention: If the AUTO is illuminated
(which means a cooking program has
already been inserted), by pushing the
button
you cancel the program and
return to manual operation.
If the oven is switch on, you must
switch off manually.