Caple C232SS - Manual (Page 22)

22
Models with tilting grill and sliding
shelves
– Assemble the sliding shelves on the
oven walls using the 2 screws (Fig.
9.6).
– In the models with catalytic panels
interpose the catalytic panels “A” with
the arrow up (Fig. 9.6).
– Position the shelf and tray on the slid-
ing shelves (fig. 9.7).
To dismantle, operate as follows:
– Unscrewing the fixing screws and
slide off the sliding shelves and the
catalytic liners (if supplied) to the oven
wall as in fig. 9.6.
The grill is secured to the rear wall of
the oven on a hinge system that
allows it to be lowered to allow proper
access when cleaning the oven ceiling
(fig. 9.5).
Fig. 9.5
Models with tilting grill and wire
racks
– Assemble the wire racks on the oven
walls using the 2 screws (Fig. 9.4).
– In the models with catalytic panels
interpose the catalytic panels “A” with
the arrow up (Fig. 9.4).
– Slide in, on the guides, the shelf and
the tray (fig. 9.3).
The rack must be fitted so that the
safety catch, which stops it sliding out,
faces the inside of the oven.
To dismantle, operate as follows:
– Unscrewing the fixing screws and
slide off the wire racks and the cat-
alytic liners (if supplied) to the oven
wall as in fig. 9.4.
The grill is secured to the rear wall of
the oven on a hinge system that
allows it to be lowered to allow proper
access when cleaning the oven ceiling
(fig. 9.5).
Fig. 9.4
A A