Cata ME 605 X - Manual (Page 38)

Door type C
Carefully lever up the glass with a flat screwdriver located in
the groove shown in the figure.
When refitting the glass, check that it is correctly fitted into the
toothed joint of the door and all around.
REMOVING THE DOOR FROM THE OVEN
To simplify cleaning the interior of the oven, the door can be
removed. The process of removing the door for the three types
is shown below:
Door type A / B2
The hinges “A” have two moving bolts “B”.
When the bolt “B” is lifted, the hinge comes out of its housing.
Then close the door to the half-way position.
Next, lift the door upwards and remove it, sliding it outwards;
hold the door by the sides close to the hinges when doing this.
To replace the door, first slide the hinges into their grooves and
open the door completely.
Remember to turn the two moving bolts “B” used to engage the
two hinges before closing the door (Fig. 3).
WARNING
• Take care not to remove the hinge locking system when tak-
ing off the door, as the hinge mechanism can spring back
suddenly.
• Never submerge the door in water for any reason.
Door type B1
Open the door fully to position “D”
Lift the two mobile links “A” of the hinges, until fixing at point
“B”.
Then close the door to the half-way position.
Next, lift the door upwards and remove it, sliding it outwards;
hold the door by the sides close to the hinges when doing this.
To replace the door, first slide the hinges into their grooves
and open the door completely.
Remember to turn the two moving links “B” used to engage
the two hinges before closing the door (Fig. X).
A
B
D
WARNING
• Take care not to remove the hinge locking system when
taking off the door, as the hinge mechanism can spring
back suddenly.
• Never submerge the door in water for any reason.
Door type C
Open the door and support it firmly.
Using a suitable screwdriver remove the lower hinge by the
part fixed to the oven.
Then remove the upper hinge from its place and take off the
door.
To replace the door, follow the same steps in reverse.
Oven accessories (Fig. 4)
The oven can be provided with lateral guides fitted to the oven
wall. Insert the grid and oven sheet provided on the lateral
guides. To remove the guides proceed as follows for the two
types:
Bars type 1
To remove the lateral guides press downwards at point A.