Chase-Durer Combat Command Automatic - Manual (Page 4)

2. Winding / Setting Local TIME
45 15
60
30
30
20 10
CHASE-DURER
COMBAT
COMMAND
AUTOMATIC
9 3
12
6
FRI 31
Position
2
is used for winding only
of setting crown
Day and Date change each time
hour hand passes midnight
(24:00 hours)
Setting crown in position
4
is
used to adjust both hour and
minute hands *
* Setting crown in position
4
Stops the Second Hand to allow synchronizing with a time signal.
There are many accurate sources for this time signal including shortwave radio frequencies that
continuously announce GMT (UTC) and the internet.
3 4 1 2
Note - When setting the time, pay attention to the Day/Date window to make sure you are setting
the time correctly for AM or PM. The Day and Date begin changing at 11PM (23:00 hours).
NOTE:
If your watch stops, it must be wound by turning the crown clockwise approximately 25 full
turns. Although the watch is automatic, the mainspring may not have enough reserve to keep it running
accurately
. Once wound, the normal movement of wearing the watch will provide enough power to
keep accurate time.