Cloud Electronics CXM2 - Manual (Page 11)

CXM User manual 10
3.06 Aux Send Master Controls
The Aux 1 Master level control is used to adjust the overall signal level at the Aux 1
output. The Aux 2 Master is identical to Aux 1.
3.07 Aux Return Control
This control is used to adjust the level of any unit connected to the Aux return socket with
a provision to monitor the signal via the PFL switch. It is obviously intended to be used by
signal processors etc. but can be used by any signal source which requires a basic input
such as a background music system etc.
3.08 Recording
The master module has two stereo pairs of output phono sockets on the rear panel to
facilitate recording mixer operator performance. The signal level present on these
connectors follows the Main output programme.
Two additional pairs of output sockets are provided with music signals only and these
signals are derived before the master fader.
3.09 Remote Music Mute
The CXM mixer has a facility to interface with a fire alarm control panel. If this facility is
used, and the fire alarm is activated, the music signals will muted. To indicate this
condition, the red "Mute" LED will flash on and off. Any currently selected PFL channels
will be cancelled, this will mute the headphone amplifier. The microphone channels will
still operate normally to organise controlled evacuation.
30-08-02 V4.0