Codan Radio MT-3 - Manual (Page 46)

USER GUIDE | MT-3 ANALOG RADIO SYSTEMS
Chapter 5: Radio System Components Page 38
CHANNEL PROGRAMMER
The CP-SC-3 synthesizer channel programmer is used to program channels 2 through 16 (and read
channel 1) of Codan MT-3 synthesized radios. The CP-SC-3 synthesizer channel programmer is
packaged in the same size of enclosure as the MT-3 receiver module, allowing it to be conveniently
mounted in any receiver subrack slot position. An interconnect cable (Type F to DB-9) connects the
front panel of the CP-SC-3 synthesizer channel programmer to any free standing synthesized receiver
or transmitter. The programmer allows the four digit Channel Designation codes to be entered into
channels 2 through 16 of the connected receiver or transmitter and will read the codes programmed
into channels 1 through 16.
Figure 5-9: CP-SC-3 Synthesizer Channel Programmer
ADV PRGM
RESET FCTN
PROGRAMMER
MADE IN CANADA
C h 0 1
1 2 3 4
MADE IN CANADA
RS232
I/O
TX/RX
DATA
I/O