Comtech EF Data CDM-710G - Manual (Page 126)

CDM-710G High-Speed Satellite Modem Revision 1
Front Panel Operation MN-CDM710G
6–50
6.3.6.3 (SELECT:) UTIL
Æ ID
Edit Circuit ID: ( E)
------------------------
To edit the Circuit ID string, select the cursor position on the bottom line using the W X arrow
keys, then edit the selected character using the ST arrow keys. Note that only the bottom line (0 to
24 characters) is available. The following characters are available:
<Space> ( ) * + - , . / 0-9 and A-Z
When the string has been composed, press
ENTER
.
6.3.6.4 (SELECT:) UTIL
ÆDisplay
Edit Display Brightness:
100% ( E)
Select a brightness levels of 25%, 50%, 75% or 100% using the ST arrow keys. Press
ENTER
when done.
6.3.6.5 (SELECT:) UTIL
Æ Firmware
IMPORTANT
These commands are for DIAGNOSTIC PURPOSES ONLY. DO NOT CHANGE
an image unless instructed to do so by Comtech EF Data customer service
technicians.
The sub-menus available through UTIL: Firmware allow viewing information about the
CDM-710G internal firmware. The modem stores two complete firmware images, and the user can
select which image will be loaded the next time the unit reboots.
Firmware Images:
Info Select ( E)
Select either Info or Select using the W X arrow keys, then press
ENTER
.
(Firmware:) Firmware Images Æ Info
Firmware Info: Bootrom
Image#1 Image#2
To view information on the Bootrom and the two images, select Bootrom, Image#1, or Image#2
using the
W X arrow keys, then press
ENTER
to continue.