Comtech EF Data MIDAS Version 4.X Basic Configuration - Manual (Page 63)

MIDAS 4.2 Basic Configuration, Rev. 1
Setup and Operation 2–29
From the main window, click Configuration then Control Channels to display the Control
Channels window. This window allows the operator to set the following Control Channel
parameters. The Control Channel window will also be displayed from a Cold Start for
the initial System Setup.
Control Channel
Placement Selection
Three selections at the top of this window allow the operator to place the
Control Channel at specific locations in the Space Segment, as follows:
• Place the control channel at the beginning of the public pool.
• Place the control channel at the end of the public pool.
• Place the control channel at the center frequencies specified below.
(Frequencies are specified in the Outbound and Inbound Center IF fields.)