6 addressing – Comtech EF Data RSU-503 User Manual
Page 41
Advertising
RSU-503 Redundancy Switch Unit
Installation
Rev. 8
25
2.6 Addressing
The following are the factory default addresses:
•
Switch is set to address 1
•
RFT A is set to address 2
•
RFT B is set to address 3
The proper M&C cable hook-up is critical:
•
RFT A must be connected to the switch Port A
•
RFT B must be connected to the switch Port B
Note: If these connections are reversed, no communications will take place.
Advertising