Crate TX50DB - Manual (Page 5)

C R A T E
5
ABOUT THE POWER SUPPLY (continued):
The TX50D may also be powered by using a 12-volt vehicle cigarette
lighter adapter, available at most electronic supply stores. Make certain
that the polarity on the adapter matches what is shown below.
Connect the small round end of the adapter to the 12VDC Automobile
adapter jack (#26, page 8), then plug the other end of the adapter into
the vehicle’s cigarette lighter socket. (In some vehicles, the ignition
switch must be in the “on” or “accessory” position to have power at the
socket.) NEVER PLUG THE SUPPLIED 15VDC CHARGER INTO THE
AMPLIFIER’S 12VDC LIGHTER PLUG!
When using the DC cigarette lighter adapter, the vehicle’s battery will
keep the amp charged to its voltage level – if the battery has a 13.5-volt
charge, the amp will charge up to 13.5 volts; if the battery is low and
only has a 10-volt charge, the amp will discharge down to 10 volts.
CAUTION! The TX50D contains a sealed, rechargeable,
lead-acid battery. Improper disposal of battery or replace-
ment with any other type may cause leakage, explosion,
and/or injury. See page 4 for additional information. Also,
refer to product warranty information.
POSITIVE NEGATIVE
This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC
Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This
equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will
not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more
of the following measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and the receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
• Consult the dealer or an experienced radio/TV technician for help.
Changes or modifications to this device not expressly approved by SLM Electronics could void the user’s authority to operate
the equipment under FCC rules.
Declaration of Conformity
Manufacturer’s Name: SLM Electronics
Corporate Headquarters: 1901 Congressional Drive, St. Louis, Missouri 63146
Primary Production Facility: 700 Hwy 202 W, Yellville, Arkansas, 72687
Product Type: Audio Amplifier
Products meet the regulations for compliance marking under:
ETL standards UL6500, UL60065, or UL813
CSA standards E60065 or C22.2 No.1-M90
CE safety standard EN60065
CE EMC standards EN55103 or EN55013 and EN61000
C-tick designation Level 2, ABN #56748810738, ARBN# N222
KETI standard K60065 (limited model approval)
Compliance Support Contact: SLM Electronics, Attn: R&D Compliance Engineer
1901 Congressional Drive, St Louis, Missouri, 63146 • Tel.: 314-569-0141, Fax: 314-569-0175