Cybex 19000 Big Iron Half Rack - Manual (Page 9)

Cybex 19000/19010 Half Rack Owner’s Manual
9
1. The solid, level surface should not deviate more than 1/8” over a 10’ distance or as defined and
required by local building and architectural codes.
Anchoring 2. of equipment must be completed by a qualified licensed contractor.
Anchoring 3. holes are provided on the feet of the frame. All anchoring locations must be used
when used when anchoring the equipment to the floor.
Due 4. to the wide variation of flooring on which machines may be anchored or installed, verify
anchoring method and anchoring fasteners with a qualified and licensed contractor.
A 5. minimum pull out force of 220 lbs/100 kgs is required for each anchor position.
Do 6. not use machine until it is properly anchored.
MAINTENANCE:
Preventative maintenance allows proper equipment operation and reduces the risk of injury. Perform
the maintenance requirements as specified in the manual.
STANDARD COMPLIANCE:
Cybex products meet or exceed applicable ASTM and EN Standards.