Wrong, Correct – Cybex 20000 Eagle NX Chest Press User Manual
Page 14
Cybex Owner’s Manual
14
4. Install each weight plate, one at a time, so wide edge of bushing faces upward and narrow
edge of bushing faces downward.
NARROW
bushing edge
WRONG
WIDE bushing
edge faces
upward
CORRECT
5. Slide top weight onto guide rods.
6. Install compression spring and top guide rod cap onto guide rod. Slide spring loaded top
guide rod cap down guide rod until cap is clear of guide rod plate and install. Repeat for
opposite side.
1
2
3
5
4
Description
1 Top guide rod cap (2)
2 Guide rod (2)
3 Guide rod plate
4 Phillips head screw (4)
5 Plastic mount
7. Install four Phillips head screws securing plastic mount to guide rod plate.
Apply weight plate decal (if not already installed on weight plates)
1. Peel off half of backing from weight plate decals, making sure that the decals remain
attached to the front sheet.
Backing
Weight
decals
Front sheet
2. Place decals front sheet in the correct position on weight plates.
3. Insert a guide pin through each hole of the decals front sheet. (A guide pin can be anything
that fits through the weight stack hole, such as a weight stack selector pin.)