D.T. Systems R.A.P.T. 1400 Series - Manual (Page 14)

14
To Test the Vibration:
1. Press Vibrate Button on the transmitter and the col-
lar unit will vibrate only.
Before testing, make sure that both units are fully
charged and the power to the Collar Receiver is “ON”.
To Test the Electronic Stimulation:
1. Place the tester firmly on the contacts
of the Collar Receiver.
2. Set the intensity (note - an intensity
level setting of 4 or less might not be
enough to light the tester).
3. Push the ‘NICK’ or ‘CONT’ button.
4. The tester light will quickly flash once when the Nick
button is pushed and light repeatedly when the
Continuous Stimulation button is pushed (the test
light will be brighter at higher intensity levels).
TESTING
To Test the Jump:
1. Press Jump Button on the transmitter and test light
brightness will reflect the user-programmed Jump
level (see page 19).
2. The intensity level will return to its original setting
when the Jump button is released.
NOTE: If the collar unit is not responding to any signals
from the transmitter, the collar may need to be repro-
grammed to the transmitter (see page 16).