Daktronics Sportsound Rack SSR-100 Operation Manual - Manual (Page 15)

Setup & Operation 9
3.2 Mixer Operation
Basic instructions are described below. For more
information about mixer operation, refer to the
Rane MLM82S Operators Manual.
 Ensure all source equipment is turned on and
operational (refer to appropriate pages).
 For each input channel (source) in use, verify the
following settings as shown in Figure 13:
- SIG/OL light is green; if this light is red,
decrease the level
- ASSIGN is set to “A+B” or “B”
Note: Inputs set to “A” will only be heard through
the announcer’s console headphones. This may be
used to listen to each input without interrupting
the main mix.
 When the input is in MONO mode, the signal goes
to both “A” and “B” outputs. The amber LED
illuminates when in MONO mode (Figure 14).
When not in MONO mode, the input signal goes
to the “B” output (as set in the factory).
 Adjust MASTER VOLUME “B” level (Figure 15) to
achieve the final output. If the OL light is red, decrease
the level.
Remember: Bad input = bad output. No adjustment on the
mixer can make a poor source sound better. For best results, be
sure to use high-quality audio files from your MP3 player or
laptop, and set the device to near full volume.
Figure 13: Input Level Adjustment
Figure 14: MONO Input
Figure 15: MASTER Output