Datatek HP-UX 10.20 (32 bit kernel - Manual (Page 37)

I P - C o m m K i t I n s t a l l a t i o n a n d A d m i n i s t r a t i o n G u i d e
f o r H P - U X – I s s u e 2 – R e l e a s e 1 . 0 . 2 2
10/13/11 Datatek Applications Inc. 37
The report should be similar to the one below:
00-12-19 17:46:20 NODE=node_name
M display connections mod mod_address
MODULE: 19
---------------
CH/PT CU/TM GROUP PKT CNT STATE TO MOD CH/PT CU/TM GROUP PKT CNT
BOARD (+ = PDD BOARD
CS/LCH or PVC, CS/LCH
PT/LCH # = RRC) PT/LCH
PT/DLCI PT/DLCI
1 **** 295 ACTIVE
2 group_name 89 SERVING
Note that channel 2 is in the SERVING state.
6.3 S TOPPING AND S TARTING
Some configuration changes require stopping and starting the IP-CommKit software to make the
changes effective. Specifically, changes to /etc/opt/dk/dkiptab require stopping and starting. You
can always do this by rebooting the host computer. However, this can be disruptive and time
consuming. A more convenient method is to log in as root, then enter the follow commands:
# sh /sbin/init.d/dkitrc stop
# sh /sbin/init.d/dkitrc start