Standby power led, Cooling option, Chapter 3 standby power led – DFI HR908-B User Manual
Page 25
Advertising
www.dfi.com
Chapter 3 Hardware Installation
25
Chapter 3
Standby Power LED
Standby
Power LED
This LED will light when the system is in the standby mode.
Cooling Option
Heat Sink with Cooling Fan
• “1” and “2” denote the locations of the thermal pads designed to contact
the corresponding components that are on HR908-B.
Top View of the Heat Sink
Bottom View of the Heat Sink
1
2
Important:
Remove the plastic covering from the thermal pads prior to mounting the heat sink
onto HR908-B.
Note:
The system board used in the following illustrations may not resemble the actual
board. These illustrations are for reference only.
Advertising