Digi-Star ERM-2.4 - Manual (Page 7)

ERM-2.4 Operators Manual
7
INSTALLATION INSTRUCTIONS
1. If mounting the ERM-2.4 using the supplied hook and loop
fasteners:
a.
See “Suggested Mounting Locations” for proper mounting
positions.
b. Wipe the mounting surface clean of dirt and debris.
c. Wipe the adhering surface and back side of ERM-2.4 clean with
alcohol or cleaner spray and allow to air dry.
d. Apply hook and loop fasteners as necessary.
e. Allow unit to cure for 12-24 hours before use.
NOTE: Adhesive will not stick to any surface at temperatures below
freezing. Install at room temperature for best results.
2. If mounting the ERM-2.4 using bolts:
a. Determine the proper sized bolt for use with connecting the ERM-
2.4 to the equipment.
b.
See “Suggested Mounting Locations” for proper mounting
configurations.
NOTE: Installing the ERM-2.4 in positions other than shown will decrease
radio range and performance.