Running self test, Low battery indication, Operators manual – Digi-Star Cab Control 2.4 User Manual
Page 9
Operators Manual
D3990
7
Example below illustrates how to set up a system with two
scales.
is set to ,
is set to minutes and
Scale #1 and Scale #2 are enabled:
NOTE: On systems with six or less scales, use scales
numbered 1 through 6.
Running Self Test
To run the self-test on the Cab Control 2.4, follow
instructions under “Setup Cab Control 2.4” steps 1 through 7
on page 6 and press [Net/Grs] in step 8.
Low Battery Indication
If the power supply voltage drops below 10.5 Volts, the
message
and
will
periodically show on the display to alert the operator of the
low battery condition.
NOTE: If
is displayed, the indicator power (not the
Cab Control 2.4 power) is below 10.5 volts.
Warning!
Disconnect the Cab Control 2.4 power cord
before jump-starting or fast-charging the
battery.