Digi-Star John Deere 1790 - Bauer Series CCS -Refuge Option - Manual (Page 5)

Scale Bracket and Load Cell Mounting Installation
D3860-US – Rev A John Deere Planter Scale 3
Rear Leg Assembly
1. Lift and support rear frame of tank. Loosen existing support hardware.
IMPORTANT
: The lifting
chains, bucket attachments, loader/skid steer or winch must be capable of lifting and controlling 1000-
1500 lbs.
2. Attach rear brackets and load cell to rear hopper frame. Keep 5/8” x 8-1/2” bolts and nuts loose.
IMPORTANT
: Use 400525 cell – 2.125 DB – 11 ft. cable for rear support. Also, make sure arrow on
end of load cell is pointing down.
3. Lower hopper frame and align rear bracket with M16 threaded holes in rear frame plate. (Tighten M16
bolts and all rear support hardware.)
4. If threaded holes are not present, weld rear support to rear frame plate.
IMPORTANT:
When welding on planter,
ground close to the weld. Do not run
electrical current through the load cell.