DNF Controls UABS-I Installation_Manual - Manual (Page 9)

Flex Control Network ® UABS-I Installation Manual 8 8 of 8
D. Ethernet Link Speed Setup
1) On the DC20 front panel, use ÏÐ keys to select “Ethernet Status”.
2) Press ENTER key. Display will show current speed selection.
3) Use the ÏÐ keys to change selection.
4) Select AUTO to use highest available speed.
5) Select 10Mbs for long Ethernet cable runs.
6) Press ENTER to save new IP address.
OR
Press ESC to exit without saving.
NOTE- New Ethernet speed selection will take effect immediately.