Echo Bear Cat SC3305 - Manual (Page 11)

7 3 INCH CHIPPER/SHREDDER
ENGLI
sH
ASSEMBLY
gasoline and diesel fuels are highly flammable and
their vapors are explosive. To prevent personal injury or
property damage:
Store fuel only in approved containers, in well ventilated,
unoccupied buildings, away from sparks or flames. A
container with a capacity of 2 gallons or less with a
pouring spout is recommended. Do not fill the fuel tank
while the engine is hot or running, since spilled fuel
could ignite if it comes in contact with hot parts or sparks
from ignition. Do not start the engine near spilled fuel.
Never use fuel as a cleaning agent. DO NOT MIX OIl
WITH FuEl.
2.5 FILL THE FuEL TaNK
use only those types of fuels that are recommended in
your engine owner’s manual.
To add fuel:
Stop engine, wait for all parts to stop moving and disconnect 1.
spark plug wire. Remove key from key switch. Allow the
engine and muffler to cool for at least three minutes.
Clean area around fuel fill cap and remove cap.
2.
using a clean funnel, fill fuel tank to 1/2” below bottom of 3.
filler neck to provide space for any fuel expansion. Install
fuel fill cap securely and wipe up any spilled gasoline.
WaRNING
2.6 add oIL
2.7 INsTaLL a baTTERY (sc3305E oNLY)
Check the oil level and, if needed, fill the engine crankcase
with the type and amount of oil specified in the engine
owner’s manual.
you will need to purchase a battery. Choose a battery that
meets or exceeds the following specifications:
CCA@ zero Degree: 200-250
Size: 7-3/4" X 5-3/16" X 7-5/16"
BCI group Size u1
Exide Cutting Edge, Type gT-H
WaRNING
To avoid sparks and a possible explosion or fire due
to a short circuit, do not touch the positive (+) battery
terminal and any surrounding metal with tools, jewelry
or other metal objects. When installing battery cables,
connect the positive (+) cable first and the negative (-)
cable last.
Figure 2.1 - Briggs Oil Fill
Figure 2.2 - Honda Oil Fill
2.8 INsTaLLING THE WHEELs, jacK
aNd HITcH (sc3240T aNd sc3270T oNLY)
Slide one wheel onto a hub and align the wheel lug 1.
holes with the hub lug holes.
Thread the wheel bolts into the holes and tighten to
2.
the proper torque. Follow an alternating cross pattern
when tightening wheel bolts.
Repeat for the remaining wheel.
3.
Install hitch jack onto hitch pole and install snap pin. 4.
Align the hitch pole assembly to the frame and secure 5.
using two 3/8" X 2-1/2" bolts, 3/8" flat washers and
3/8" nylock nuts.