EM Acoustics i-1 ultra-compact satellite loudspeaker - Manual (Page 11)

11
i-Series User Manual
www.emacoustics.co.uk
Installation of the DA-1 Power Amplifier Module
The i-12 subwoofer can accept the EM Acoustics DA-1 digital power amplifier module. One DA-1 is used to drive
one i-12, and in this configuration the DA-1 runs in two channel mode, with each pair of drive units driven by one
channel.
To install the DA-1, lie the enclosure on its front. Using a 4mm Allen Key, carefully undo the six M5 socket head
bolts holding the connector panel door in place on the rear of the enclosure. Remove the connector panel door
and disconnect the four-pin connector on the cable. Put the connector panel aside for future reinstatement.
Connect the four-pin connector into the chassis socket on the bottom edge of the DA-1. Carefully place the DA-1
into the amplifier module housing within the i-12 enclosure, reinstate and retighten the M5 socket head bolts.
The DA-1 must be set to the i-12 program before use, otherwise severe damage can occur to your subwoofer.
Please consult your DA-1 user manual for information on recalling programs, and a program listing.