ESI SW10K - Manual (Page 10)

10
Technical Specifications
- Type: Powered Subwoofer
-Subwoofer Driver: 10" black paper cone with high temperature voice coil and damped
rubber surround.
- Frequency Response: 30Hz - 180Hz, Adjustable 50Hz – 180Hz
- Amplifier Power: 100W@100Hz, 4 ohm, 0.1% THD
- Dynamic Power: 120W
- S/N Ratio: >100dB below full output
- Input Connectors: 2 x XLR R/L Balanced Input Connector
2 x TRS Balanced/ Unbalanced Input Connector
-Output Connectors: 2x XLR Balanced output for Satellites
1x XLR Balanced output for Extra Sub
- Controls : Level, Phase, Subwoofer Frequency, Satellite Frequency
- Switches : Power On/Off slide switch,
L&R XLR Outputs “HPF Bypass” On/Off Slide Switch.
- Input Impedance: 20K ohms balanced, 10K ohms unbalanced
- Input Sensitivity: 150 mV input produces full output with Input Sensitivity control at
maximum.
-Protection: over temperature, shorting, an external main fuses.
- Indicators: Power ON (Red)/ Protection (Red) /Operation(Green)
- Power Requirements: Factory programmed for either 115V ~50/60Hz,
230V~50/60Hz or 100V~50/60Hz;
Power via detachable 3 circuit line cord.
- Cabinet: vinyl laminated MDF
- Dimension (unit): 384mm(H) x 354mm(W) x 384mm(D)
- Dimension (Shipping Carton): 492mm(H) x 488mm(W) x 458mm(D)
- Net Weight: 12.5 Kg (27.5 lbs) /unit (without packing)
- Shipping Weight: 16.5 Kg (36 lbs) /unit (with shipping carton)
Remarks: Above specifications are subject to change without notice.