ESI uniK 08 - Manual (Page 9)

ESI uniK 08
9
3. vent port – uniK 08 is a vented box speaker system with a vent port on the rear panel. Make sure
you are not blocking the vent port (i.e. by putting the speaker too close to a wall) or the sound
colour will be changed.
4. input level adjustment (volume control knob) – use the volume control knob to set the proper
input level from the sound source. Make sure to setup all speakers accordingly. When set to 0dB
(middle position), the input level is set to the recommended calibrated level to reach the most
optimised dynamic response on the output (expecting a balanced XLR +4dBu or unbalanced TS -
10dBV input signal).
5. treble attenuation adjustment – to match your uniK 08 to certain room acoustic requirements, a
change in the treble attenuation can be made with this switch. The default and recommended setting
is 0dB and normally you can always keep it there. Always make sure to setup all speakers
identically.
6. bass roll off adjustment – this switch allows you to match uniK 08 better to a subwoofer and in
special situations where the room acoustics require it. The default and recommended setting is 50Hz
and normally you can always keep it there. Always make sure to setup all speakers identically.
7. power switch – when you push the power switch, uniK 08 will be turned on, and –surprise– it
will be turned off when you push the power switch again.
8. power port with ext. fuse – use this connector to plug in the detachable 3-circuit line cord that
connects to the power outlet. The connector contains a replaceable fuse (T2AL/250V).
5. General Information
Trademarks
ESI, uniK and uniK 08 are trademarks of ESI Audiotechnik GmbH. Other product and brand names
are trademarks or registered trademarks of their respective companies.
Correspondence
For technical support inquiries, contact your nearest dealer, local distributor or ESI support online at
www.esi-audio.com.
Disclaimer
All features and specifications subject to change without notice.
Parts of this manual are continually being updated. Please check our web site www.esi-audio.com
occasionally for the most recent update information.