ETA Mariner bez exteronu - Manual (Page 38)

- Using the sponge (installed on the other side of the tool), spread the detergent solution all
over the surface to be washed in order to dissolve the dirt. Any solid dirt such as bits of
dried mortar should be removed with the scraper located on the tool face.
- After carefully spreading the wet dirt over the surface, spray the detergent/water mix all
over the window. After this spraying, the detergent with the dissolved dirt can be collected
from the window surface.
- When collecting the dirt with the vacuum cleaner, it is recommended to start along the top
edge of the window and to proceed with even sweeps all across the window
(Figure 37). To wipe the window surface clean and collect the dissolved dirt, keep
pressing the tool against the window. The vacuum cleaned surface must be dry, in order
to avoid any “ smearing” on the cleaned surface.
- When washing windows, set the cleaner power to the minimum (Figures 20, 21).
X. USEFUL TIPS
1. As long as no detergent is sprayed during the wet cleaning, keep the pump switched
OFF. The pump is fitted with a self-resetting thermal cut-out. Once tripped, it switches
the pump OFF (the pilot light is still on). Once the cut-out has cooled down sufficiently,
the pump is restarted. Increased noise of the pump operation indicates insufficient
volume of water in the detergent tank.
2. If the carpet has been shampooed with other detergents shortly before being wet
vacuum cleaned, foam may develop in the cleaner waste water tank which can escape
through the outlet micro-filter. In that case, unplug the cleaner off the mains and empty
the waste water tank. Undesirable foam development can be prevented if you pour
a coffee cup of vinegar in the waste water tank.
3. To negotiate obstacles ( such as thresholds or stairs), turn the cleaner OFF and lift the
cleaner and carry it by the handle to avoid any risk of the cleaner tipping over
or damaging the travelling wheels. We recommend switching the motor OFF when
carrying the cleaner.
4. Should the cleaner tip over during cleaning, lift it up while leaving the motor running and
switch the motor OFF afterwards. After a short while, the motor can be switched ON
again.
XI. MAINTENANCE
Always store the cleaner in a dry place and in a sufficient distance from any sources
of heat (such as the fireplace, stove, oven, heating radiator) and protect it from the
atmospheric effects (such as rain, sunshine). Clean the cleaner surface with a wet soft
cloth, never use abrasive or corrosive detergents! Store the cleaner properly cleaned in a
dry, dust-free place, out of reach of children and minors.
Cleaners
After finishing every “ wet” cleaning to keep the appliance to high hygiene standard, wash
(shower) the waste water tank and the tank cover under running water and leave to dry
(fig. 43). Treat the appliance surface with soft damp rag, do not use aggressive and coarse
detergents!
38
GB