ETA Verto - Manual (Page 21)

CAUTION
– The maximum suction effect will be reached by a clean filter and an empty container.
– Do not use any aggressive washing or cleaning agents or hot water to clean the filter.
– The filter is not intended for washing in a dishwasher.
– Cleaning the filter will not restore its original colour, but it will restore its filtration
properties.
– Neglecting filter cleaning may lead to breakdown of the vacuum cleaner!
– Make sure that the binding surfaces and sealing elements are functional.
– We recommend replacing the filter twice a year or when it cannot be cleaned properly
or if it is damaged. You can buy a replacement filter in the elektro shop chain.
Filter replacement
Disassemble the movable parts of the cleaner for changing of the filter (pic. 8). Remove the
B1 filter by lightly sliding out the ring that holds the filter attached to the plastic body. Slide
the new filter on and fix it thoroughly reversely.
Storing accessories
You may put the accessory ( D, E, F) into the holder C (valid for ETA2442), or to a safe
place. Store the adaptor G on a safe, dry and dustless place inside the house, keep it out
of reach of children and persons sui juris.
IV. MAINTENANCE
Disconnect the charger from the appliance before any maintenance. Store the vacuum
cleaner at a dry place, far enough from heat sources (e.g. fireplace, stove, heating
element) and protect it against weather conditions (e.g. rain, sunshine). Treat the surface
of the vacuum cleaner and the charger (only when disconnected from the electric socket)
with a wet cloth, do not use abrasive and aggressive cleaning agents! You can use
a dishwasher for accessories B, B2, E and F. Never dry plastic moldings over a heat
source (e. g. heater, electric/gas stove).
V. TROUBLESHOOTING
Problem Cause Solution
Motor won‘t start The battery is discharged Recharge the battery
The „0/I“ button is not Press the “0/I ” button
switched on
The container The parts of the filtration Check / correct insertion of the protector
cannot be fixed to system not inserted and the filter in the container
the vacuum cleaner properly in the container
The suction Dust container full Empty the container
performance is not Clogged filter Clean or replace the filter
sufficient The accessories are Remove the blocking objects
blocked
The battery is discharged Recharge the battery
GB
21 / 34