Exacq exacqVision IP Camera Quick Start Guide User Manual
Exacqvision ip camera quickstart guide
exacqVision IP Camera Quickstart Guide
www.exacq.com
#500-0024
+1.317.845.5710
+44.1438.310163
USA (Corporate Headquarters)
Europe/Middle East/Asia
Page 1 of 17
7/15/2014
This document is supplemental to the quick start guide and software user manual software user manual shipped with your
system. Both documents can be downloaded at
This document describes the camera configuration software provided by major IP camera manufacturers for use prior to
configuring your exacqVision system. For additional information, please consult with the camera manufacturer’s software
instructions.
Most systems can be installed with the following steps:
1. Install the servers as shown in the exacqVision Quick Start Guides.
2. Confirm the camera has the correct firmware version a
3. Configure the cameras with a fixed IP address as shown in this document.
4. Test camera-to-server communications by browsing to the camera from the server.
5. Configure your exacqVision server as shown in the user manual.
6. Consult the Exacq Knowledge Base a
for additional information.
Each IP camera manufacturer provides a utility to find cameras on the local network and set their IP addresses. This utility is
typically available on the software CD shipped with your camera, or from the camera manufacturer’s web site. Please refer
to the documentation provided by your camera’s manufacturer if you have questions after reading this guide.
Supported Manufacturers:
1. American Dynamics
2. ACTi
3. Arecont
4. AXIS
5. Ganz
6. IQinVision
7. Panasonic
8. Pelco
9. Samsung
10. Sony
11. Vivotek
NOTE: This manual does not discuss cameras interfacing with ONVIF or RTSP protocols. See Chapter 4 of the user manual
and the Exacq Knowledge Base for additional information on configuration of these cameras.