Flowserve FRBHJC - Manual (Page 39)

®
8.5 General arrangement drawing
The typical general arrangement drawing and any
specific drawings required by the contract will be sent to
the Purchaser separately unless the contract specifically
calls for these to be included into the User Instructions.
If required, copies of other drawings sent separately to
the Purchaser should be obtained from the Purchaser
and retained with these User Instructions.
9 CERTIFICATION
Certificates, determined from the contract requirements
will be provided with this manual. Examples are
certificates for CE marking and ATEX marking. If
required, copies of other certificates sent separately to
the Purchaser should be obtained from Purchaser for
retention with the User Instructions. See section 1.9,
Noise level, for details of typical noise certification.
10 OTHER RELEVANT DOCUMENTATION
AND MANUALS
10.1 Supplementary User Instruction
manuals
Supplementary instruction determined from the contract
requirements for inclusion into User Instructions such as
for a driver, instrumentation, controller, sub-driver, seals,
sealant system, mounting component etc are included
under this section. If further copies of these are
required they should be obtained from the purchaser for
retention with these User Instructions.
Where any pre-printed set of User Instructions are used,
and satisfactory quality can be maintained only by
avoiding copying these, they are included at the end of
these User Instructions such as within a standard clear
polymer software protection envelope.
10.2 Change notes
If any changes, agreed with Flowserve Pump Division,
are made to the product after its supply, a record of the
details should be maintained with these User
Instructions.
10.3 Additional sources of information
Reference 1:
NPSH for Rotordynamic Pumps: a reference guide,
Europump Guide No. 1, Europump & World Pumps,
Elsevier Science, United Kingdom, 1999.
Reference 2:
Pumping Manual, 9
th
edition, T.C. Dickenson,
Elsevier Advanced Technology, United Kingdom, 1995.
Reference 3:
Pump Handbook, 2
nd
edition, Igor J. Karassik et al,
McGraw-Hill Inc., New York, 1993.
Reference 4:
ANSI/HI 1.1-1.5
Centrifugal Pumps - Nomenclature, Definitions,
Application and Operation.
Reference 5:
ANSI B31.3 - Process Piping.