0 assembly – Flowserve Swing Check Valves 2.5-24 User Manual
Page 26
Advertising
Swing Check Valves FCD ADENIM0013-00
25
6.0
ASSEMBLY
(Continued)
6.1.1.2.3 Pin Mounted on Bracket in Body (Fig 15)
With the hinge assembly supported, the hinge support (007) should be placed over
the hinge end and the hinge pin (041) (with the retaining pin (257) in place) inserted
into position. Prior to installing the assembly in the body, position the two spring
pins (258) on the pads in the body. The assembly can now be lowered over the
pins into position on the pads. Put a washer (Tab Lock) (251) on each hinge support
bolt (289), insert them through the hinge support bracket into the body and tighten.
Once they are in place, the tabs on the lock washer should be bent over.
FIGURE 15
Advertising