Error messages – Flowserve DDC-100 Master Station II User Manual
Page 69
FCD LMAIM5001-00
DDC-100 Master Station II Installation and Operation Manual
69
Flow Control Division
Limitorque Actuation Systems
16
Error Messages
Error messages appear when a user attempts to initiate a function out of sequence or while another process is operating.
Should a user attempt an unsafe task, the following error messages will be displayed.
Figure 16-1: Control Error
This screen will be displayed when control of a MOV is attempted on the Standby processor.
Figure 16-2: Configuration Error 1
This screen will be displayed when configuration of the Standby processor is attempted.
Configuration Error
Please use the ACTIVE unit to
configure the network.
This unit is configured
in STANDBY mode.
<< Back
Control Error
This unit is configured
in STANDBY mode.
Please use the ACTIVE unit to control
the network.
<< Back