Initial inspection and storage instructions – Flowserve L120-190 through L120-2000 User Manual
Page 7
7
Limitorque
®
L120-190 through L120-2000 FCD LMENIM1203-00 – 10/11
flowserve.com
c
WARNING: Read this Installation and Maintenance Manual carefully and completely before
attempting to store the actuator. Be aware of the electrical hazards.
3.1 Product Identification
The actuator nameplate is located on the back of the actuator opposite the limit switch controls
compartment. The nameplate contains the following information:
• Limitorque name
• Point of manufacture
• Actuator size
The motor nameplate is located on the motor. The nameplate contains the following information:
• ID number
• Run torque
• RPM
• Full load amps
• Insulation class
• Space heater size
• Service Factor
• Cycles
• Ambient temperature
• Start torque
3
Initial Inspection
and Storage Instructions
• Order number
• Serial number
• Customer tagging
• Enclosure type
• Volts
• Locked rotor amps
• Duty
• Horsepower
• Phase
• Motor code
• Connection diagram