Flowserve MX Dashboard Limitorque - Manual (Page 11)

11
FCD LMENIM2338-01
torque setup
Allowed changes: Torque % value from 40-100% [contact
Limitorque before increasing torque values as the actuators
are configured for the desired torque output at the factory].
Position Limit setup
Note: Encoder values are read only. Precision parameter is
the only allowed change.
Modutronic setup
Allowed changes: Modutronic Enabled/Disabled, Proportional
Band, Dead Band, Fail Action, Position, Polarity, and Delay After
Stop.
network setup option
Allowed changes: Refer to specific protocol documentation
for detailed information. If a network option is installed, the
appropriate network type will be displayed. Protocols supported:
Profibus DP/PA, DeviceNet, Modbus or Not Installed.