Flowserve SRL63-A User Manual
Page 6
6
– continued –
– continued –
The logic unit monitors the following times:
■
Interval time: This is the time interval at which, depending on the mode (24 h / 72h operation), the con-
necting lines have to be purged.
■
Standby period: The purging process must be initiated during this time. The standby period begins
when the interval time has elapsed.
■
Purging time: During this period, the purging process must be performed through actuation of the
valves. Actuation of the valves is signalled by means of the limit switches; similarly, when the electrode
of the low-level limiter is exposed, this is sensed through the output contact of the corresponding level
switch. If a signal is not received within the purging time, the safety circuit is opened. Since a low-level
limiter may be bypassed for a maximum of 5 minutes, monitoring of the purging time is a safety-rele-
vant function.
The interval time is started when the logic unit is switched on. The display of the PLC shows the full hours
of the remaining time. This can be synchronized at any time by closing an interconnection valve (E or D),
i.e. the purging time begins and the interval time is reset to its initial value (e.g. 24h, 72h etc.).
During operation, the standby period is started at the end of the interval time, which is immediately reset
to its initial value (e.g. 24h, 72h etc.). The PLC then starts the purging time when an interconnection valve
(E or D) leaves the end position "Open".
During the purging time, the output contact of the low-level limiter is bypassed. This bypass is triggered
by the undelayed contact of the safety time-lag relay and limited to 5 minutes by the delayed contact of
this relay.
Once all valves signal that they have reached their initial positions and the level switch of the low-level
limiter senses that the level electrode is exposed, the purging process has ended and the bypassing of the
low-level limiter is terminated.
In the event that the mains supply fails during the purging time, the bypassing of the low-level limiter is
cancelled and the safety circuit is opened. If the mains supply is switched on again, the bypass remains
deactivated and the safety circuit is only closed again after the purging process has been completed prop-
erly.
Expiry of the purging time and standby period, as well as deactivation of the safety circuit, are indicated
by means of pilot lamps.
The safety circuit is opened when the standby time or the purging time is exceeded, and it
is only closed again when the purging process has been completed properly.
Note