Annex, Switching controller level electrode – Flowserve NRS 2-40 User Manual
Page 27
Advertising
27
Annex
The terminal strip of the NRS 2-40 is live during operation.
This presents the danger of electric shock.
Cut off power supply before mounting or removing the equipment.
Danger
The individual node IDs must be manually adjusted on the equipment.
Please observe the installation instructions of the device in question.
Switching
controller
Level
electrode
Factory set default node IDs
Attention
■
Do not assign the same node ID twice within the CAN bus network.
Fig. 10
8
If several systems of the same kind are to communicate in one CAN bus network, be
sure to assign one node ID for each individual system component (e. g. controller).
Detach terminal strips in order to change the code switch setting .
Assigning / changing node ID
A
8
Advertising