System updates – Dish Network Solo 351 User Manual
Page 88
Page 83
System Updates
•
If the telephone line is not connected properly, the receiver displays a
failure message. In this case, check the telephone connection and then
repeat the test.
Note
: If you have the receiver connected to a DSL (Digital Subscriber
Line) phone line, it may cause this test to fail. If so, you will need to
install a DSL filter between the receiver and the phone jack on the wall.
You should be able to get a DSL filter from your DSL provider, or your
local electronic parts store.
System Updates
Your receiver includes a feature that allows you to set the time in
which your receiver downloads
Program Guide
information. When the
Updates
feature is enabled, the receiver will shut off every day at the same
time receive a software update. The default time for this feature is 3:00 a.m.
1. Press the MENU button.
2. Select
System Setup
.
3. Select
Installation
.
4. Select
Updates
.
5. Highlight the
Activation
field.
6. Press the UP or DOWN ARROW button to enable or disable the
automatic update feature.
Note
: If you disable this feature, no new
Program Guide
information
will be available until the you turn off the receiver.
7. Highlight the
Time Set
field.
8. Use the NUMBER PAD buttons to set the time that you want the
system to update the
Program Guide
.
9. Highlight the
AM/PM
field.
10. Press the UP or DOWN ARROW button to set
AM
or
PM
.