FSR DV-HXT-2 - Manual (Page 8)

8
EQ SW set up table according to UPT cable length
Dip switch position “0” stands for the strongest HDMI signal level for the longest
possible transmission length while “7” stands for the weakest HDMI signal level for
the shortest transmission length.
Please adjust the signal level from “7” to “0” and stop turning the rotary switch
whenever the audio/video is playing normally at receiver box first.
Tip:
If you see blinking image or no image on the display, please adjust the rotary control switch to
a larger number.
If you see pixel noise on the image on the display, please adjust the rotary control switch to a
smaller number.
If the rotary switch adjustments above do not provide a satisfactory image, please
set up transmitter and receiver rotary control switches as shown below.
NOTE: Rotary Switch settings “8” and “9” are not used.
Reference adjust TMDS signals
CABLE LENGTH: 33ft (10M) @1080p
TRANSMITTER RECEIVER
SWITCH SETTING 0 1 2 3 4 5 6 7 0 1 2 3 4 5 6 7
REC X X X X X X X IDEAL X X IDEAL
NR X X X X X
REC=Recommended NR=Not Recommended
CABLE LENGTH : Up to 150ft(45M)@1080p
TRANSMITTER RECEIVER
SWITCH SETTING 0 1 2 3 4 5 6 7 0 1 2 3 4 5 6 7
REC X X X IDEAL X IDEAL X X
NR X X X X X X X
REC=Recommended NR=Not Recommended
Caution:
* EQ switch set up value is made up based on CAT-5E UTP cable/1080p and
therefore the value may be different when you use CAT6 cable or pass patch
panels
* Minimum CAT cable length should be longer than 25ft (depending on cable quality)
Do not use with network hubs or routers, it will damage the units.